Very satisfied! I was searching for several days, but nope; till I discovered your webside and there it was at a very reasonable price. Keep up the good work!
Paul
Flanders
Text excerpt from page 36 (click to view)
MAINTENANCE
Fitting the cutting unit
1. Place the Rider on a flat surface and apply the parking brake. Check that the lever for setting the cutting height is in the lowest position. Make sure the support wheels are fitted to the cutting unit (1). 2. Grasp the handle at the front (BioClip 90) or hold the frame of the cutting unit (2) and slide the unit underneath the rider mower, making sure that the tongue on the cutting unit (3) engages correctly.
6017-159
3
1 2
8009-438
3. Insert the bolt and secure it with a locking pin.
WARNING! Observe caution to avoid trapping your hand.
6017-120
4. Press down the frame and insert the pin. Fit the drive belt around the drive wheels of the cutting unit. 5. Hook up the height adjustment strut. 6. Fit the front cover. 7. Secure the collet�s spring, see ring in the diagram below.